Previous
The machine selects a suitable size of copy paper automatically based on the detected original size and the reproduction ratio you select.
You cannot use the paper bypass location with this function.
Original sizes and orientations that can be used with Auto Paper Select are as follows (when copied at a ratio of 100%):
(mainly Europe)
A0
, A1
, A2, A3, A4, B1 JIS, B2 JIS, B3 JIS, B4 JIS
(mainly North America)
Engineering
E (34 × 44)
, D (22 × 34), C (17 × 22), B (11 × 17), A (81/2 × 11)Architecture
E (36 × 48)
, D (24 × 36), C (18 × 24), B (12 × 18), A (9 × 12)Others
81/2 × 12
, 81/2 × 13, 81/2 × 14, 11 × 14, 11 × 15, 12 × 141/2, 30 × 21, 30 × 42
When Using the Copy Application
About how to use the application's screen, see "[Copy] Screen".
When Using the Copier (Classic) Application
Make sure that [Auto Paper Select] is selected.
Place the original, and start scanning.
Only the paper input locations specified to [Do not Display] or [Recycled Paper] in [Paper Type] and also specified to [Yes] in [Apply Auto Paper Select] under [Tray Paper Settings] can be selected in Auto Paper Select mode. Paper input locations with a lock mark (
) will not be automatically selected. For details, see "Tray Paper Settings", Connecting the Machine/ System Settings.If you change the paper type, copying may take longer to start.
When [Auto Paper Select] is selected, copying may take slightly longer since the machine selects the copy paper after scanning the original.
If no paper suitable for the size and reduce/enlarge ratio you have specified is loaded in the paper input locations, load paper of the required size in a paper input locations. Alternatively, you can select a suitable reduce/enlarge ratio for the paper currently loaded in the paper input locations. After doing one of the above, place your original again.
