Skip header
 

Use the "spoolsw" command to view and configure the Job Spool settings.

You can only specify diprint, trap, lpr, ipp, ftp, sftp, wsprn, and smb (TCP/IP) protocols.

The "spoolsw" command for configuring Job Spool settings is available only when the hard disk is installed.

View settings

The Job Spool setting appears.

msh> spoolsw

Job Spool setting

msh> spoolsw spool {on|off}

  • Specify "on" to enable Job Spool, or "off" to disable it.

Resetting Job spool setting

msh> spoolsw clear job {on|off}

  • When the machine power is turned off during job spooling, this determines whether to reprint the spooled job.

Protocol configuration

msh> spoolsw diprint {on|off}

msh> spoolsw lpr {on|off}

msh> spoolsw ipp {on|off}

msh> spoolsw smb {on|off}

msh> spoolsw ftp {on|off}

msh> spoolsw sftp {on|off}

msh> spoolsw wsprn {on|off}