Skip header
 

Loading Paper into Paper Trays

Every paper tray is loaded in the same way.

In the following example procedure, paper is loaded into Tray 1.

Important

  • Check the paper edges are aligned at the right side.

  • If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side fences may slip out of place.

  • When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the side fences are squeezed too tightly against the paper, the edges may crease or the paper may misfeed.

1Check that paper in the paper tray is not being used, and then pull the tray carefully out until it stops.

Tray 1 illustration

2Square the paper and load it print side up.

Do not stack paper over the limit mark.

Tray 1 illustration

3Carefully push the paper tray fully in.

Note