Previous
Depending on the cause of the problem, do one of the following:
<Sheet bending>
There is airflow in the room.
Minimize the airflow. For instance, turn the air conditioner off.
Sheets are curled upward.
Load the sheets the other way up.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Go to the next step.
In the 03: [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Skilled Operators] menu, select 0301: [Adjust Paper Curl] and specify "Adjust
Curl".If "Off" is selected, change the value to "Weak". If "Weak" is selected, change the value to "Medium". If "Medium" is selected, change the value to "Strong".
Coated paper is being used.
In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Skilled Operators] menu, set 0617: [Adjust Output Fan Level] to [Increase Air Volume].
Standard paper is being used.
In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Skilled Operators] menu, set 0615: [Output Trail Edge Press Setting] to [On].
In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Skilled Operators] menu, set 0616: [Output Fan Setting] to [On].
<One sheet pushing out another or sheets becoming crimped>
Sheets are curled downward.
Load the sheets the other way up.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Go to the next step.
In the 03: [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Skilled Operators] menu, select 0301: [Adjust Paper Curl] and specify "Adjust
Curl".If "Off" is selected, change the value to "Weak". If "Weak" is selected, change the value to "Medium". If "Medium" is selected, change the value to "Strong".
Coated paper is being used.
In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Skilled Operators] menu, set 0617: [Adjust Output Fan Level] to [Increase Air Volume].
Standard paper is being used.
In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Skilled Operators] menu, set 0615: [Output Trail Edge Press Setting] to [On].
In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Skilled Operators] menu, set 0616: [Output Fan Setting] to [On].
