Previous
Depending on the cause of the problem, do one of the following:
Coated paper is being used.
In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Skilled Operators] menu, set 0617: [Adjust Output Fan Level] to [Increase Air Volume].
There is airflow in the room.
Minimize the airflow. For instance, turn the air conditioner off.
Printed sheets are curled.
Load the sheets the other way up.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Go to the next step.
In the 03: [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Skilled Operators] menu, select 0301: [Adjust Paper Curl] and adjust the degree of decurling.
<Single-sided printing: Printed side face down>
To correct curls facing up, specify "Adjust 
Curl".
To correct curls facing down, specify "Adjust 
Curl".
<Single-sided printing: Printed side face up/Duplex printing>
To correct curls facing up, specify "Adjust Curl".
To correct curls facing down, specify "Adjust Curl".
Select "Strong", "Medium" or "Weak" depending on the degree of decurling required.
There are too many stacked sheets.
Reduce the number of the stacked sheets. To do this, suspend printing and remove the stacked sheets, and then resume printing.
To suspend printing, press the [Suspend/Resume] key on the finisher.
To resume printing, press the [Suspend/Resume] key on the finisher.
Thin coated paper is used.
When stapling thin coated paper, the stapled sheets may be scratched or they may jam.
In the 03: [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Skilled Operators] menu, set 0301: [Adjust Paper Curl] to "Adjust Curl". To control the level of decurling, select "Weak" if the present setting is "Off", "Medium" if the present value is "Weak", or "Strong" if the present value is "Medium".
