The solution depends on whether the area within 107 mm (4.2 inches) of the trailing edge is denser or fainter.
<If the area within 107 mm (4.2 inches) of the trailing edge is fainter>
In [Advanced Settings] for the custom paper, check the present value in 016: [Transfer Timing Roller Feed Speed Adj]. Is it higher than +0.5%?
Yes |
Contact your service representative. |
No |
Increase the value by 0.1 percentage point. |
Print the image. Has the problem been resolved?
Yes |
Finished! |
No |
Repeat Steps 1 and 2. If the problem persists even though you have increased the value to +0.5%, contact your service representative. |
<If the area within 107 mm (4.2 inches) of the trailing edge is denser>
In [Advanced Settings] for the custom paper, check the present value in 016: [Transfer Timing Roller Feed Speed Adj]. Is it lower than -0.5%?
Yes |
Contact your service representative. |
No |
Decrease the value by 0.1 percentage point. |
Print the image. Has the problem been resolved?
Yes |
Finished! |
No |
Repeat Steps 1 and 2. If the problem persists even though you have decreased the value to -0.5%, contact your service representative. |
After performing the solution, it is recommended to perform the color calibration of the external controller. For details see, Operating Procedure for Color Calibration.