Carry out the following sequence of procedures. Terminate the sequence as soon as the problem is resolved.
Procedure 1: Enable the AC mode
Set 049: [Paper Transfer AC Mode] to [On] in [Advanced Settings] for the custom paper.
Print the image. Has the problem been resolved?
Yes |
Finished! |
No |
Proceed to "Procedure 2: Adjust the density". |
Procedure 2: Adjust the density
In the 02: [Machine: Image Quality] group on the [Adjustment Settings for Skilled Operators] menu, select 0203: [Adjust Maximum Image Density] and increase the all colors' value by 1 step.
Select 0201: [Adjust Image Density/ DEMS] and execute [Image Density Adjustment: Manual Execute].
Print the image. Has the problem been resolved?
Yes |
Finished! |
No |
Repeat Steps 1 to 3. If the problem persists even though you have increased the value in 0203: [Adjust Maximum Image Density] to "5", contact your service representative. |
After performing the solution, it is recommended to perform the color calibration of the external controller. For details see, Operating Procedure for Color Calibration.