Previous
Follow the procedure below to set the printer to receive an IP address automatically using DHCP. The DHCP feature is active by default, so this procedure is only required if you have changed the default settings.
When [Auto-Obtain (DHCP)] is selected, you cannot configure the IP address, subnet mask, or gateway address.
Press the [Menu] key, and then select the setting items using the [
] or [
] key.
Select [Host Interface] 
Press [OK]
Select [Network] Press [OK]
Select [Machine IPv4 Address] Press [OK]
Select [Auto-Obtain (DHCP)] Press [OK]
You can check the detected addresses by pressing [IP Add.], [Subnet M], and [Gateway].
If you enable DHCP Option 204, you can simultaneously specify a number of the printer's network settings and printer settings. You can download the manual for DHCP Option 204 from the manufacturer's website.
