Skip header
 

Replacing Other Consumables

Refer to the maintenance guide provided with the new items for the replacement.

WARNING

  • Do not use a vacuum cleaner to remove spilled toner (including used toner). Absorbed toner may cause a fire or explosion due to electrical contact flickering inside the vacuum cleaner. However, it is possible to use a vacuum cleaner that is explosion-proof and dust ignition-proof. If toner is spilled on the floor, remove the spilled toner slowly using a wet cloth, so that the toner is not scattered.

CAUTION

  • Store toner (new or used), toner containers, and components that have been in contact with toner out of reach of children.

  • If toner or used toner is inhaled, gargle with plenty of water and move into a fresh air environment. Consult a doctor if necessary.

  • If toner or used toner gets into your eyes, flush immediately with large amounts of water. Consult a doctor if necessary.

  • If toner or used toner is swallowed, dilute by drinking a large amount of water. Consult a doctor if necessary.

  • When removing jammed paper or replacing toner, avoid getting toner (new or used) on your clothing. If toner comes into contact with your clothing, wash the stained area with cold water. Hot water will set the toner into the fabric and make removing the stain impossible.

  • When removing jammed paper or replacing toner, avoid getting toner (new or used) on your skin. If toner comes into contact with your skin, wash the affected area thoroughly with soap and water.

  • The fusing unit becomes very hot. When installing a new fusing unit, turn off the printer and wait at least an hour after power off before replacing parts. Not allowing the printer to cool may result in burns.

Important

  • Exposure to light may result in the lower performance of the drum unit. Replace the unit as quickly as possible.

  • Do not pull out the drum unit quickly or with force as it may fall.

  • When installing the drum unit, do not tilt, turn upside down, or shake it.

  • When installing the print cartridge, hold it with both hands and insert it into the printer fully until it reaches the position indicated on the label attached on the printer. If the front cover does not close, do not force it. Check if the print cartridge is properly installed.

Drum Unit

When the following message is displayed on the control panel, you will be requested to replace the drum unit in the near future. Prepare a new drum unit for replacement.

“Rplcmnt Rqrd Soon:Drum Unit”

When the following message is displayed, it is time to replace the drum unit. You can still continue printing with the existing drum unit, but print quality is not guaranteed. If printed pages come out blurred or with streaks or spots, replace the drum unit with a new one.

“Rep Rqrd: Drum U. (PrtSusp) ”

“Replace Drum Unit.”

When the above message is displayed, it is recommended that you replace the drum unit as soon as possible. If you continue printing, the following message is displayed and you will not be able to print again until you replace the drum unit.

“Rep Rqrd: Drum U. (PrtSusp)”

“Printing was suspended. It will resume after the Drum Unit is replaced.”

Maintenance Kit

Replace the Maintenance Kit when the following messages appear on the display:

“Replacmnt Requrd Maint. Kit”

When the following message appears on the display, the fusing unit should be replaced soon.

“Repl Requrd Soon Maint. Kit”

PreviousNext