Skip header
 

Order of Option Installation

You can attach up to three paper feed units. Up to 2,100 sheets of paper can be loaded.

WARNING

  • When placing the printer on a desk, only one paper feed unit can be installed. When installing two or more units, use the original caster table and place them on the floor. Also, be sure to ask your sales or service representative for ways to prevent overturning.

  • When installing the paper feed units while using the original caster table, be sure to ask your sales or service representative for ways to prevent overturning.

1Attach the paper feed unit.

Attach the paper feed unit to the bottom of the printer.

2Install the SDRAM module.

3Install the hard disk.

4Install the optional interface board.

Install in the slot of the printer.

Only one interface board can be installed.

5Insert SD card options.

Insert in the SD card slot of the printer.

There are two slots for SD cards.

Each slot supports different types of SD cards.

If you want to use two or more SD cards that can be inserted in the same slot, contact your sales or service representative.

PreviousNext