Skip header
 

When Using Metallic Paper

Glossy ghosting may occur on metallic paper due to the slipperiness and low fusibility of the metallic paper surface.

To improve the throughput when printing on metallic paper, feed the paper in the following way.

Note

  • To adjust the following settings, pre-register the type of paper in use as a custom paper. For details about registering custom papers, see "Registering a Custom Paper", Paper Settings.

  • After performing the solution, it is recommended to perform the color calibration of the external controller.

1Register the paper in the custom paper profile.

2In [Advanced Settings] for the custom paper you are using, adjust the interval between the feeding of each sheet.

<Printing in full color/Printing in black and white/Printing in full color including the clear toner while the special color is not set to high quality>

Set 129: [Paper Feed Interval Setting: Productivity] to "100".

<Printing in full color including the clear toner and the special color is set to high quality/printing in full color including the white toner>

Set 130: [Paper Feed Interval Setting: Quality] to "100".

3Print the image. Is the luster ghost image within the permissible range?

Yes

Finished!

No

At present, you cannot improve the throughput. Change the setting back to the previous one.
PreviousNext