Previous
After receiving a print job, the machine usually stops to let the fusing temperature reach an appropriate level for printing.
The waiting time for the fusing unit to cool down may be quite long, especially before printing on thin paper. By decreasing the fusing temperature during standby, you can reduce the waiting time.
By changing the fusing temperature to feed paper after warm-up, you can also reduce the waiting time.
When printing on paper other than thin paper, we recommend leaving the above settings unchanged.
To adjust the following settings, pre-register the type of paper in use as a custom paper. For details about registering custom papers, see "Registering a Custom Paper", Paper Settings.
After performing the solution, it is recommended to perform the color calibration of the external controller.
In the [Machine: Image Quality] group on the [Adjustment Settings for Skilled Operators] menu, decrease the temperature by 10°C in 0207: [Adjust Fusing Temperature on Standby].
Decrease the value in [Temperature on Standby Mode], [Temperature on Panel Off Mode], and [Temperature Before Performing a Process] by 10°C.
If the problem persists, proceed to the next step.
Register the paper in the custom paper profile.
Set the value in 090: [Adj Fsng Tmp to Trnsf Ppr: Ppr: Qual] or 092: [Adj Fsng Tmp to Trnsf Ppr: Ppr: Qual: S] to "11".
When printing in special color only, select 092: [Adj Fsng Tmp to Trnsf Ppr: Ppr: Qual: S].
