Previous
The solution depends on whether letter folding is applied to multiple sheets or a single sheet.
<When letter folding is applied to multiple sheets>
Load the paper the other side up.
Print the image. Has the problem been resolved?
Yes |
Finished! |
No |
Go to the next step. |
In the [Finishing: Fold] group on the [Adjustment Settings for Skilled Operators] menu, set 0704: [Letter Fold-in Position 1 (Multi-sheet Fold)] to "0.0 mm".
In [General Features] in [System Settings], set [Letter Fold-in Position] for multiple sheets to "7 mm".
Print the image. Has the problem been resolved?
Yes |
Finished! |
No |
Contact your service representative. |
<When letter folding is applied to a single sheet>
This procedure is applied especially to coated paper.
To adjust the following settings, pre-register the type of paper in use as a custom paper. For details about registering custom papers, see "Registering a Custom Paper", Paper Settings.
In [General Features] in [System Settings], set [Letter Fold-in Position] for a single sheet to "7 mm".
In [Advanced Settings] for the custom paper you are using, select 140: [Letter Fold-in Posn 1: Single-sheet Fold].
Increase the value by 0.2 mm.
Print the image. Has the problem been resolved?
Yes |
Finished! |
No |
Repeat Step 2 to 4. If the problem persists even though the setting value is 4 mm larger than the maximum value, contact your service representative. |
