Change the folding position by adjusting the position of the paper edge stopper for folding.
For multi-sheet folding, change the folding position using the following settings in the [Finishing: Fold] group on the [Adjustment Settings for Skilled Operators] menu:
0701: [Half Fold Position (Multi-sheet Fold)]
0702: [Letter Fold-out Position 1 (Multi-sheet Fold)]
0703: [Letter Fold-out Position 2 (Multi-sheet Fold)]
0704: [Letter Fold-in Position 1 (Multi-sheet Fold)]
0705: [Letter Fold-in Position 2 (Multi-sheet Fold)]
For single-sheet folding, change the folding position using the following settings in the [Advanced Settings] for the custom paper you are using:
135: [Adjust Z-fold Position 1]
136: [Adjust Z-fold Position 2]
137: [Half Fold Position: Single-sheet Fold]
138: [Letter Fold-out Posn 1: Single-sheet Fld]
139: [Letter Fold-out Posn 2: Single-sheet Fld]
140: [Letter Fold-in Posn 1: Single-sheet Fold]
141: [Letter Fold-in Posn 2: Single-sheet Fold]
142: [Double Parallel Fold Position 1]
143: [Double Parallel Fold Position 2]
144: [Adjust Gate Fold Position 1]
145: [Adjust Gate Fold Position 2]
146: [Adjust Gate Fold Position 3]