Previous
Depending on the cause of the problem, do one of the following:
<Sheet bending>
There is airflow in the room.
Minimize the airflow. For instance, turn the air conditioner off.
Sheets are curled upward.
<If the decurler unit is used>
In the [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Skilled Operators] menu, set 0304: [Adjust Paper Curl] to [Adjust 
Curl].
To control the level of decurling, select "Weak" if the present setting is "Off" or "Strong" if the present value is "Weak".
<If the decurler unit is not used>
Load the sheets the other way up.
Coated paper is being used.
In the [Finishing: Finisher] group on the [Adjustment Settings for Skilled Operators] menu, set 0617: [Adjust Output Fan Level] to [Increase Air Volume].
Standard paper is being used.
In the [Finishing: Finisher] group on the [Adjustment Settings for Skilled Operators] menu, set 0615: [Output Trail Edge Press Setting] to [On].
In the [Finishing: Finisher] group on the [Adjustment Settings for Skilled Operators] menu, set 0616: [Output Fan Setting] to [On].
<One sheet pushing out another or sheets becoming crimped>
Sheets are curled downward.
<If the decurler unit is used>
In the [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Skilled Operators] menu, set 0304: [Adjust Paper Curl] to [Adjust 
Curl].
To control the level of decurling, select "Weak" if the present setting is "Off" or "Strong" if the present value is "Weak".
<If the decurler unit is not used>
Load the sheets the other way up.
Coated paper is being used.
In the [Finishing: Finisher] group on the [Adjustment Settings for Skilled Operators] menu, set 0617: [Adjust Output Fan Level] to [Increase Air Volume].
Standard paper is being used.
In the [Finishing: Finisher] group on the [Adjustment Settings for Skilled Operators] menu, set 0615: [Output Trail Edge Press Setting] to [On].
In the [Finishing: Finisher] group on the [Adjustment Settings for Skilled Operators] menu, set 0616: [Output Fan Setting] to [On].
