Skip header
 

Solution:

<If scratches or streaks appear on the side 2 of the paper or continuous noise results>

You can lessen the problem by decreasing the paper feed speed of the decurler unit.

  1. In the [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Skilled Operators] menu, check the present degree of decurling (Off, Weak, or Strong) in 0304: [Adjust Paper Curl].

  2. In [Advanced Settings] for the custom paper you are using, adjust the paper feed speed of the decurler unit.

    • If the degree of decurling is set to "Off", reduce the value in 105: [Decurler Feed Speed Adj: Curl Adj Off] by 0.5%.

    • If the degree of decurling is set to "Weak", reduce the value in 106: [Decurler Feed Speed Adj: Curl Adj Weak] by 0.5%.

    • If the degree of decurling is set to "Strong", reduce the value in 107: [Decurler Feed Speed Adj: Curl Adj Strg] by 0.5%.

  3. Print the image. Has the problem been resolved?

    Yes

    Finished!

    No

    Keep decreasing the value by 0.5% until the problem is resolved.

    If the problem persists even though the setting has reached its minimum value, contact your service representative.

<If scratches, streaks, or creases appear on the side 1 of the paper>

You can lessen the problem by increasing the paper feed speed of the decurler unit.

  1. In the [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Skilled Operators] menu, check the present degree of decurling (Off, Weak, or Strong) in 0304: [Adjust Paper Curl].

  2. In [Advanced Settings] for the custom paper you are using, adjust the paper feed speed of the decurler unit.

    • If the degree of decurling is set to "Off", increase the value in 105: [Decurler Feed Speed Adj: Curl Adj Off] by 0.5%.

    • If the degree of decurling is set to "Weak", increase the value in 106: [Decurler Feed Speed Adj: Curl Adj Weak] by 0.5%.

    • If the degree of decurling is set to "Strong", increase the value in 107: [Decurler Feed Speed Adj: Curl Adj Strg] by 0.5%.

  3. Print the image. Has the problem been resolved?

    Yes

    Finished!

    No

    Keep increasing the value by 0.5% until the problem is resolved.

    If the problem persists even though the value has reached its maximum value, contact your service representative.
PreviousNext