Skip header
 

To eliminate curling without using the decurler unit, lower the heat roller temperature.

Lowering the temperature may result in:

Note

  • To adjust the following settings, pre-register the type of paper in use as a custom paper. For details about registering custom papers, see "Registering a Custom Paper", Paper Settings.

  • To use the decurler unit, specify 0304: [Adjust Paper Curl] in the [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Skilled Operators] menu.

  • After performing the solution, it is recommended to perform the color calibration of the external controller.

  • Check the toner fusibility as follows:

    • The printed image does not come off.

    • The toner does not come off even if it is lightly rubbed by a nail.

    • The toner does not come off even if it is rubbed by the cloth for cleaning the contact glass.

1In [Advanced Settings] for the custom paper you are using, adjust the fusing heat roller temperature.

<Printing in full color including the clear toner and the special color is set to high quality/printing in full color including the white toner>

Decrease the value in 086: [Fusing Heat Roller Temp. Adjust.: Qual.] by 5°C

<Printing in full color/Printing in full color including the clear toner while the special color is not set to high quality>

Decrease the value in 085: [Fusing Heat Roller Temp. Adjust.: Prod.] by 5°C

2Print a full-page solid-fill image. Has the problem been resolved?

Yes

Finished!

No

Further reduce the value by 5°C until the problem is resolved. Adjust the temperature while checking fusibility.

If the problem persists, contact your service representative.
PreviousNext