You can lessen the problem by decreasing the paper feed speed of the decurler unit.
In the [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Skilled Operators] menu, check the present degree of decurling (Off, Weak, or Strong) in 0304: [Adjust Paper Curl].
In [Advanced Settings] for the custom paper you are using, adjust the paper feed speed of the decurler unit.
If the degree of decurling is set to "Off", reduce the value in 0105: [Decurler Feed Speed Adj: Curl Adj Off] by 0.5%.
If the degree of decurling is set to "Weak", reduce the value in 0106: [Decurler Feed Speed Adj: Curl Adj Weak] by 0.5%.
If the degree of decurling is set to "Strong", reduce the value in 0107: [Decurler Feed Speed Adj: Curl Adj Strg] by 0.5%.
Print the image. Has the problem been resolved?
Yes |
Finished! |
No |
Keep decreasing the value by 0.5% until the problem is resolved. If the problem persists even though the setting has reached its minimum value, contact your service representative. |
Decreasing the paper feed speed of the decurler unit may result in creases, scratches, or paper jams if thin paper is used.