Perform procedure (a). If the problem persists, perform procedure (b).
Procedure (a):
In the [Machine: Maintenance] group on the [Adjustment Settings for Skilled Operators] menu, select 0506: [Smooth Fusing Belt] and execute [For Uneven Gloss (Short Time)].
Print the image. Has the problem been resolved?
Yes |
Go to the next step. |
No |
Execute [For Uneven Gloss (Short Time)] in 0506: [Smooth Fusing Belt] until the problem is resolved. |
Register the paper in the custom paper profile.
To prevent this problem, polish the fusing belt by the fusing belt smoothing roller more frequently. Configure the following settings in [Advanced Settings] for the custom paper you are using.
<Printing in full color/Printing in black and white/Printing in full color including the clear toner while the special color is not set to high quality>
Set 102: [Fusr Blt Smthng: PprTyp/Wt Coef: Prod] to "100".
<Printing in full color including the clear toner and the special color is set to high quality/printing in full color including the white toner>
Set 103: [Fusr Blt Smthng: PprTyp/Wt Coef: Qual] to "100".
Procedure (b):
Adjust the paper feed interval
<Printing in full color/Printing in black and white/Printing in full color including the clear toner while the special color is not set to high quality>
Decrease the value in 129: [Paper Feed Interval Setting: Productivity] by 20.
<Printing in full color including the clear toner and the special color is set to high quality/printing in full color including the white toner>
Decrease the value in 130: [Paper Feed Interval Setting: Quality] by 20.
Print the image. Has the problem been resolved?
Yes |
Finished! |
No |
Repeat Steps 1 to 2. If the problem persists, contact your service representative. |
After performing the solution, it is recommended to perform the color calibration of the external controller.
Performing procedure (b) will decrease throughput.