This section describes how to connect an Ethernet interface cable to the Gigabit Ethernet port.
If you use an Ethernet interface cable that supports 1000BASE-T, set [Ethernet Speed] to [Auto Select: Enable 1Gbps] in [Interface Settings] in [System Settings].
|
If the main power switch is on, turn it off.
Use the following Ethernet cables.
When using 100BASE-TX/10BASE-T:
Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5 or more
When using 1000BASE-T:
Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5e or more
Make sure the main power switch is turned off.
Connect the Ethernet interface cable to the Gigabit Ethernet port.
Connect the other end of the Ethernet interface cable to a network connection device such as a hub.
Turn on the main power switch of the machine.
Indicator (green)
When 10BASE-T is operating, the LED is lit green.
Indicator (orange)
When 100BASE-TX is operating, the LED is lit orange.
Indicators (both orange and green)
When 1000BASE-T is operating, both LEDs are lit.
When Energy Saver mode is enabled, the LEDs may not light up.
For details about how to turn on the main power switch, see "Turning on the main power", Getting Started.
For details about installing the printer driver, see "Installing the Printer Driver", Printer Driver Installation Guide.