Previous
To protect it from shock and vibration during transit, this machine comes packaged in cushioning foam and secured with tape. Remove these protective materials after bringing the machine to where it will be installed.
|
|
Removed tape is dirty. Be careful not to let it touch your hands or clothes.
Do not grip the tray area when lifting the machine.
Do not allow paper clips, staples, or other small metallic objects to fall inside the machine.
Remove the plastic bag.
Lift the machine using the inset grips on both sides of the machine.
Lower the machine slowly and carefully to prevent trapping your hands.
When moving the machine, do not hold on the handle on tray 1 as doing so could cause a malfunction.
Remove the adhesive tape attached on the machine's exterior.
The actual machine may come with adhesive tape attached in different positions. Make sure to check the machine's exterior for all protective materials, and remove them completely.
Open the rear cover.
Remove the adhesive tape from the machine and the envelope lever.
Pull up the envelope lever.
Remove the adhesive tape from the fusing unit and the machine.
Close the rear cover.
Open the ADF, and then remove the protective materials.
Open Tray 1, and remove the protective materials.
Close Tray 1.
When you have finished unpacking, do the following:
If you want to use the machine with optional accessories installed, see Installing Options.
If you want to use the machine without optional accessories installed, see Loading Paper .
