This section explains how to connect an Ethernet interface cable to the Ethernet port.
If the main power switch is on, turn it off.
Use the Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5 or more.
Make sure the power is switched off.
Connect the Ethernet interface cable to the Ethernet port.
Connect the other end of the Ethernet interface cable to a network connection device such as a hub.
Turn on the main power switch of the printer.
Indicator (yellow)
When 100BASE-TX is operating, the LED is lit yellow. When 10BASE-T is operating or the printer is not connected to a network, it is turned off.
Indicator (green)
When 10BASE-T is operating, the LED is lit green. When 100BASE-TX is operating or the printer is not connected to a network, it is turned off.
Use an Ethernet interface cable that supports the speed that you selected for "Ethernet Speed".
Check the type of the plug before connecting.
Do not pull the connected cable forcefully. Make sure the cable is properly connected. Otherwise, it might become disconnected or somebody might trip on it.
Using a cable with some connectors or converters may result in an improper connection.