Skip header
 

Auto Color Calibration

1Press the [User Tools/Counter] key.

User Tools/Counter key illustration

2Press [Maintenance].

3Press [Auto Color Calibration].

4Press [Start].

To perform auto color calibration using the copy function, press [Start] in Copier Function. To perform auto color calibration using the printer function, press [Start] in Printer Function.

5Press [Start Printing].

  • When performing auto color calibration using the printer function

    Select test patterns from [Test Pattern 1 600 multiplication 600 dpi], [Test Pattern 2 1800 multiplication 600 dpi], [Test Pattern 3 9000 multiplication 600 dpi], [Test Pattern 4 1200 multiplication 1200 dpi], or [Test Pattern 5 3600 multiplication 1200 dpi] and then press [Start Printing].

    Operation panel screen illustration

6Place the test pattern on the exposure glass, and then press [Start Scanning].

7Press the [User Tools/Counter] key.

Note

  • The test pattern will not be read if it is set into the ADF.

  • The test pattern will be printed on an A4, 81/2 multiplication 11 size page. If these sheets are not available, A3 or B4 JIS (Japanese Industrial Standard) will be used. Make sure to check the paper set into the paper tray.

  • Set the test pattern in the following way:

    Illustration of setting the test pattern

  • Make sure to set the test pattern on the exposure glass, and then two or three white sheets, same size as the test pattern, above the test pattern.

PreviousNext