Skip header
 

Enabling WSD Using Web Image Monitor

To use this machine as a WSD scanner, you must first configure the following settings using Web Image Monitor on a client computer:

Use the following procedure to enable both WSD (Pull Type).

1On the [Start] menu of the client computer, click [Computer], and then click [Network].

When using Windows Vista, on the [Start] menu, click [Network].

2Right-click the icon for this machine, and then click [View device webpage].

When using Windows Vista, double-click the icon for this machine.

3Click [Login].

4Enter your login user name and password in the [Login User Name] and [Login Password] boxes respectively, and then click [Login].

Consult your administrator if you require a login user name and password.

5On the menu in the left frame, select [Device Management], and then click [Configuration].

When using Windows Vista, on the menu in the left frame, click [Configuration].

6Under [Scanner], click [Initial Settings].

7Select [WSD] in [Use WSD or DSM].

8Set [Prohibit WSD Scan Command] to [Do not Prohibit].

9Click [OK].

Note

  • To use IPv6, set [WSD (Device)] or [WSD (Scanner)] for IPv4 to inactive (disabled).

  • In an IPv6 environment, only link local addresses can be used for WSD communication.

  • For details about displaying Web Image Monitor, see "Monitoring and Configuring the Machine", Connecting the Machine/ System Settings. For details about using Web Image Monitor, see Web Image Monitor Help.