Wireless LAN

Specify the communication mode of the wireless LAN.

Default: [Infrastructure Mode]

Specify SSID to distinguish the access point in [Infrastructure Mode] or [802.11 Ad-hoc Mode].

The characters that can be used are ASCII 0x20-0x7e (32 bytes).

The connection with a wireless LAN device can be made without entering the SSID of the access point when blank or "ANY" is entered in the SSID field.

Specify the channel to use when [802.11 Ad-hoc Mode] has been selected. Set the channel that matches the type of the wireless LAN being used. Available channels may differ depending on the country.

The following channels are available:

• IEEE 802.11 a/b/g/n Wireless LAN

  Frequency range:

  2412–2462 MHz (1–11 channels)

  5180–5240 MHz (36, 40, 44 and 48 channels)

Default: [11]

Specify the encryption of the Wireless LAN.

Default: [Off]

If you select [WEP], always enter a WEP key. If you select [WPA2], specify the encryption and authentication methods.

Specify "WPA2", when [Communication Mode] is set to [Infrastructure Mode].

• WEP

  If you select [WEP], enter a WEP key.

  For a 64-bit WEP key, enter the key using either 10 hexadecimal characters or 5 ASCII characters.

  For a 128-bit WEP key, enter the key using either 26 hexadecimal characters or 13 ASCII characters.

• WPA2

  • WPA2 Authent. Method

    Select either [WPA2-PSK] or [WPA2].

    If you select [WPA2-PSK], enter the pre-shared key (PSK) of 8–63 characters in ASCII code.

    When [WPA2] is selected, authentication settings and certificate installation settings are required. For details about setting methods, see Security Guide.

You can configure Wireless LAN Easy Setup using Wi-Fi Protected Setup.

If you perform Wi-Fi Protected Setup, select [Push Button] or [Enrollee].

Default: [Push Button]

If you perform this setup, the settings required for a wireless LAN connection will be automatically specified. The settings below are configured automatically:

• SSID

  The value is the one that is specified by an access point.

• Authentication Method

  WPA2-PSK: Off

• Encryption Method

  CCMP (If the authentication method is WPA2-PSK)

• PSK

  The value is the one that is specified by an access point (If the authentication method is WPA2-PSK).

Wi-Fi Protected Setup is enabled if [LAN Type] is set to [Wireless LAN].

If Wireless LAN Easy Setup is set, the settings for SSID, encryption method, authentication method, and PSK that you have specified for the Wireless LAN connection are reconfigured.

When using infrastructure mode, press [Wireless LAN Signal] to display the machine's radio wave status.

You can return the wireless LAN settings to their defaults.