Skip header
 

The machine assembles copies as sets in sequential order.

Important

  • You cannot use the bypass tray with Rotate Sort.

Sort/Shift Sort

Copies are assembled as sets in sequential order.

To use Shift Sort, a finisher or the internal shift tray is required. Each time the copies of one set or a job are delivered, the next copy is shifted to separate each set or job.

Illustration of Sort

Rotate Sort

Every other copy set is rotated by 90 degrees (PortraitLandscape) and delivered to the copy tray.

Illustration of Sort

To use the Rotate Sort function, two paper trays loaded with paper of the same size and type, but in different orientation (PortraitLandscape), are required. For details, see "Tray Paper Settings", Connecting the Machine/ System Settings.

1Press [Finishing].

Operation panel screen illustration

2Select [Sort] or [Rotate Sort], and then press [OK].

Operation panel screen illustration

3Enter the number of copy sets using the number keys.

4Place the originals.

To confirm the type of finishing, press the [Sample Copy] key.

5Press the [Start] key.

Note

  • If you are copying from the exposure glass, a single copy of each original is made first. If the first copy set is acceptable, you can make the remaining copy sets by pressing the [Sharp] key. The time required for copy sets to be delivered varies depending on the print settings.

  • Paper sizes and orientations that can be used in the Rotate Sort function are as follows:

    • A4PortraitLandscape, A5PortraitLandscape, B5 JISPortraitLandscape, 81/2 × 11PortraitLandscape, 71/4 × 101/2PortraitLandscape, 41/8 × 91/2PortraitLandscape, C5 EnvPortraitLandscape, C6 EnvPortraitLandscape, DL EnvPortraitLandscape, 16KPortraitLandscape

  • When using the Rotate Sort function, the capacity may be reduced.

  • When the number of copies exceeds capacity, copying stops. If this happens, remove copies from the tray to resume copying.

  • The number of sheets that can be placed in Internal tray 1 is 500. For details about the number of sheets that can be placed in other output trays, see "Specifications", Maintenance and Specifications.

  • You can change the settings for the Sort function under [Input / Output] in User Tools. For details, see Input / Output.