Skip header
Help
 

Basic Operation for Scan to USB (SG 3110SFNw only)

This section describes the basic operation for sending scanned files to a USB flash drive.

CAUTION


  • Keep USB flash memory devices out of reach of children. If a child accidentally swallows a USB flash memory device, consult a doctor immediately.

Important

  • This machine does not support the use of USB flash drives connected to external USB hubs. Insert your USB flash drive directly into the USB flash drive port located at the top left corner of the machine.

  • Certain types of USB flash drives cannot be used.

1Insert your USB flash drive into the USB flash drive port.

USB flash disk port Illustration

The message “Save Scn Data to USB” appears on the display.

2Press the [Scanner] key.

3Place the original on the exposure glass or in the ADF.

4Press the [B&W Start] or [Color Start] key.

To scan in color, set [Original Type] to [Full Color: Text/Photo] in [Options].

To scan in black and white, set [Original Type] to anything except [Full Color: Text/Photo] in [Options].

  • To cancel scanning, press the [Clear/Stop] key.

  • When using the exposure glass, place the next original on the exposure glass, and then press the [B&W Start] or [Color Start] key. Repeat this step until all originals are scanned.

    When all originals have been scanned, press [#] to start sending the scanned file.

5Wait until the message “Sending...” disappears.

The scanned file is created in the root directory of the USB flash drive.

6Remove the USB flash drive from the machine.