Skip header
 

Basic Procedure for Delivering Files

Important

  • You must register destinations and senders in advance using the ScanRouter delivery software *1 installed on the delivery server.

*1 The ScanRouter delivery software is no longer sold or supported. With the GlobalScan NX (optional), you can also use this function.

1Display the initial scanner screen.

  • When using the standard operation panel

    Press the [Home] key on the bottom left of the control panel, and press the [Scanner] icon on the [Home] screen.

    Home key illustration

  • When using the Smart Operation Panel

    Press the [Home] key on the top left of the control panel. Flick the screen to the left, and then press the [Scanner] icon on the Home screen 4.

2Make sure that no previous settings remain.

If a previous setting remains, press the [Reset] key.

3Press [Swtch Dest.List] to select [Delivery Server], and then press [OK].

Operation panel screen illustration

If [Swtch Dest.List] is not displayed, press [Delivery Dest.].

4Place originals.

5If necessary, specify the scan settings according to the original to be scanned.

Operation panel screen illustration

Example: Scanning an original in color/2-sided mode.

  • Press [Scan Settings], and then press [Full Color: Text / Photo] in the [Original Type] tab.

  • Press [Original Feed Type], and then press [2 Sided Original].

For details, see Various Scan Settings or Entering the Subject of the E-mail to Be Transmitted via the Delivery Server.

6Specify the destination.

You can specify multiple destinations.

For details, see Specifying Delivery Destinations.

7If necessary, press [Sender Name] to specify the sender.

For details, see Specifying the Sender.

8Press the [Start] key.

Note

  • By pressing [Manual Entry] on the network delivery scanner screen, you can send a file by e-mail via the delivery server's network. For details about entering the e-mail address directly, see Entering an E-mail Address Manually.

  • You can use the Message Disposition Notification function when sending e-mail via delivery server. An e-mail is sent to the sender selected in Step 7, notifying him/her that the recipient has read his/her e-mail. To specify this setting, press [Recept. Notice].

  • To enable the Return Receipt function, you must specify the SMTP e-mail transmission settings using ScanRouter delivery software. For details about specifying this setting, see the ScanRouter delivery software manual. Note, however, that if the e-mail software used at the destination does not support Message Disposition Notification (MDN), e-mail notification that the e-mail has been opened may not be sent.

  • Register the sender's e-mail address using the ScanRouter delivery software in advance.

  • If you press [Preview] and then start scanning while [Preview] is selected, the Preview screen appears. You can use this screen to check how the originals are scanned and the scan setting used for scanning. After checking the preview, you can specify whether to send the file or not. For detail, see "[Preview] screen under the scanner function", Getting Started.

  • To cancel scanning, press the [Stop] key. Check the information displayed in the dialog box, and then press any button.

  • You can also store a scan file and simultaneously deliver it. For details, see Simultaneous Storage and Delivery.

  • After scan files are delivered, the destination, sender, and subject fields will be automatically cleared. If you want to preserve the information in these fields, contact your local dealer.