Skip header
 

Programming/Changing a Scan Size

The procedure is the same for programming and changing.

1Press [Facsimile Features].

2Press [Scan Settings].

3Press [Program / Change / Delete Scan Size].

4Make sure that [Program / Change] is selected.

5Select [Program Size 1] or [Program Size 2].

6Enter a horizontal size using the number keys, and then press [Sharp].

Operation panel screen illustration

Each time you press [mm] or [inch], the units switch between "mm" and "inch".

If you enter a length and press [mm] or [inch], the length is converted automatically according to the unit (fractions are rounded off). For example, when you enter [2], [2], and [0] in millimeters and change to "inch", the length "8.7 inch" is shown on the display. If you press [mm] again, "221 mm" is displayed.

7Select a vertical size.

The displayed vertical size differs depending on the selected unit.

8Press [OK].

9Press [Exit] twice.

Note

  • You can use documents longer than 355.6 mm (14 inches) with the User Parameter (switch 14, bit 1) in the Parameter Settings. For details about Parameter Setting, see Parameter Settings.