Input / Output

You can select to have Batch mode or SADF mode displayed when you press [Original Settng].

Default: [Batch]

In SADF mode, an original must be placed within a specified time after the previous original has been fed.

Default: [5 second(s)]

You can adjust this time from 3 to 99 seconds in increments of 1 second.

When memory becomes full while scanning originals, the machine can make copies of scanned originals first, and then automatically proceed scanning remaining originals.

Default: [Off]

• On

  You can leave the machine unattended to make copies, but sorted pages will not be sequential.

• Off

  When memory becomes full, the machine stops operation allowing you to remove the copy pages delivered on the output tray.

If you select [Yes] in this function, the machine rotates the image correctly.

Default: [No]

Orientation-fixed (top to bottom) or two-sided paper might not be printed correctly depending on how the originals and paper are placed. For details, see "Loading Orientation-fixed Paper or Two-sided Paper", Paper Specifications and Adding Paper.

Specify which staple type has priority to be shown on the initial screen.

Default for "Staple Position 1": [Staple: Top 1]

Default for "Staple Position 2": [Off]

Default for "Staple Position 3": [Off]

Default for "Staple Position 4": [Off]

You can select which key is displayed with higher priority for "Finishing Types" on the simple screen.

Default for "Simplified Screen: Finishing Types 1": [Do not Display]

Default for "Simplified Screen: Finishing Types 2": [Do not Display]

Default for "Simplified Screen: Finishing Types 3": [Do not Display]