Skip header
 

Size Magnification

Use this function to calculate a reproduction ratio based on the lengths of the original and copy.

Illustration of Size Magnification

Specify the lengths of the original and copy. The machine selects an enlargement or reduction ratio so that manual calculation is not required.

1Press [Reduce / Enlarge].

Operation panel screen illustration

2Press [Size Magnification].

3Enter the length of the original with the number keys, and then press [Sharp].

Operation panel screen illustration

4Enter the length of the copy with the number keys, and then press [Sharp].

5Press [OK] twice.

Note

  • You can enter sizes between 1 to 999 mm (0.1 to 99.9 inches) in increments of 1 mm (0.1 inches).

  • The reproduction ratio is between 25 and 400%. However, if the originals are placed in the ADF, the maximum reproduction ratio is 200%. To copy originals at a reproduction ratio above 200%, you must place them on the exposure glass.

  • If the calculated reproduction ratio falls below the minimum reproduction ratio, the calculated reproduction ratio will be adjusted to the minimum ratio. If the reproduction ratio is over the maximum reproduction ratio, it will be adjusted to the maximum ratio. If this happens, with some ratios, parts of the image might not be copied or margins will appear on copies.