Skip header
 

Converting Colors

Copies by changing a certain color in the original to another color. Up to four colors can be converted at the same time.

Illustration of Convert Color

1Press [Full Color].

Operation panel screen illustration

2Press [Edit / Color].

3Press [Color].

4Press [Convert Color].

5Select any one item from [Conversion 1] to [Conversion 4].

6Select the color to be converted.

Operation panel screen illustration

7Select the new color.

You can adjust the density of the color in four steps.

To select user color, press [User Color], and then select the color.

To change two colors or more, repeat Steps 5 to 7.

8Press [OK] three times.

9Place the originals, and then press the [Start] key.

Note

  • The full color counter values will increase.

  • The width of the color to be converted can be adjusted in five levels. When the width of the color is set to [Wider] under [Color Sensitivity] in User Tools and red has been specified, colors close to orange and purple will be converted. You can change the setting. For details, see Adjust Color Image.

  • User colors should be registered in advance. For details about how to register a user color, see Registering User Colors.