Skip header
 

You can specify the reproduction ratio in increments of 1%.

Illustration of Zoom

To specify a reproduction ratio, enter the ratio using the number keys or specify the ratio with [Plus] or [Minus].

This section describes how to enter the ratio using the number keys.

1Press [Reduce / Enlarge].

Operation panel screen illustration

2Press [Number keys].

3Enter the desired ratio with the number keys, and then press [Sharp].

Operation panel screen illustration

4Press [OK] twice.

5Select the paper tray.

6Place the originals, and then press the [Start] key.

Note

  • When specifying the ratio with [Plus] or [Minus], press [Reduce / Enlarge], and then select a preset ratio which is close to the desired ratio. Pressing [Plus] or [Minus] changes the ratio in increments of 1%. Pressing and holding down [Plus] or [Minus] changes it in increments of 10%.

  • You can select a ratio regardless of the size of an original or copy paper. With some ratios, parts of the image might not be copied or margins will appear on copies.

  • For details about the base point, see Reducing or Enlarging Originals.