Skip header
 

When sending a fax document using the ARDF, the machine can stamp a circle mark at the bottom of the original so that you can confirm that each page has been scanned.

Stamp only works when scanning from the ARDF. One-pass duplex scanning ADF does not support the Stamp function.

When sending a two-sided document, the document is marked at the bottom of the front page and top of the rear page.

Region A icon(mainly Europe and Asia)

For details about the optional units required for this function, see "Functions Requiring Optional Configurations", Getting Started.

Illustration of Stamp

1Press [Original Feed Type].

Operation panel screen illustration

2Press [Stamp].

3Press [OK].

Note

  • This stamp indicates that the original has been successfully stored in memory for Memory Transmission, or successfully sent by Immediate Transmission.

  • When the stamp starts getting lighter, replace the cartridge. For details, see "Replacing the Stamp Cartridge", Maintenance and Specifications.

  • If a multi-page feed or paper jam occurs, the originals are not sent properly and not stamped. If you find a page that is not stamped, send only that page again.

  • A paper jam during Parallel Memory Transmission may cause the transmission to fail even if stamping is performed.

  • You cannot turn the Stamp function on or off while an original is being scanned.