Previous
To prevent documents being sent to the wrong destination, you can configure the machine to display the destination again after it has been entered and before the file is sent.
If you want to enable this function, contact your service representative.
Note that the entered destination will not be displayed again if you are sending the fax by any of the following means:
Scanning without entering a destination (storing documents, storing documents in Information Boxes)
On Hook Dial
Manual Dial
Specify the destination.
Press the [Start] key.
Check the specified destination and transmission settings.
To start transmission, press the [Start] key again.
To change the destination, press [Exit], and then change the settings.
