Closed area method
The line designating the area must be a closed loop.
Put the command sheet on top of the original.
Using a black, red, or blue felt tip pen, draw a line around the area to designate. The line should have a thickness of at least 1mm.
Make sure there is no break in the line.
Draw the line at least 2mm (0.08 inches), away from the image so that the whole image can be recognized.
a = Line marking the designated area
b = 2mm (0.08 inches)
c = Image within the designated area
The line marking the designated area should be more than 2mm (0.08 inches), from any neighboring image.
a = 2mm (0.08 inches)
b = Neighboring image
c = Line marking the designated area
d = Image within the designated area
