Attaching and Detaching the Paper Feed Unit
This section explains how to attach and detach the paper feed unit.
|
Before installing or removing options, always disconnect the power cord plugs from the wall outlet.
Attaching the paper feed unit
Press and hold down the [Power] key until it turns off, and then unplug the power cord.
Disconnect the USB cable or Ethernet cable.
Take the paper feed unit out of the box, and remove the tape.
Position the paper feed unit close to the machine.
Align the connecting parts of the machine and paper feed unit, and then lower the machine onto the paper feed unit.
Grip the center area at the base of the machine's sides. Lift it slowly and do not strain your body.
Attach the clamping plate, and then secure it with a coin screw. (SG 7100DN)
Connect the power cord, USB cable, or Ethernet cable.
Align the paper feed unit and machine using their corners.
When the machine is placed on top of the paper feed unit, installation is complete.
Do not tilt the machine.
Be careful not to trap your fingers.
Up to two paper feed units can be attached. (SG 3110DN/SG 3110DNw)
To install two paper feed units, put the upper paper feed unit (Tray 2) on the lower paper feed tray (Tray 3) first, and then lower the machine onto the upper paper feed unit (Tray 2).
After attaching an option, check that the printer driver has recognized it. See Specifying Settings on [Accessories] Tab
, Displaying the Machine Status on a Macintosh.After attaching the paper feed unit, you must register where to start printing on paper loaded in the paper feed unit. See Registration
.
Detaching the paper feed unit
Press and hold down the [Power] key until it turns off, and then unplug the power cord.
Disconnect the USB cable or Ethernet cable.
Remove the coin screw, and then detach the clamping plate. (SG 7100DN)
Remove the machine and place it on a nearby flat and stable surface, and then detach the paper feed unit from the place where the machine was installed.
Grip the center area at the base of the machine's sides. Lift it slowly and do not strain your body.
Place the machine in the previous place.
Connect the power cord, USB cable, or Ethernet cable.
Do not tilt the machine.
Be careful not to trap your fingers.
