Skip header
 

Printing with Windows (PCL 5c)

Important

  • The default setting is duplex printing. If you want to print on only one side, select [Off] for the duplex setting.

  • If you send a print job via USB 2.0 while the printer is in Low Power mode or Sleep mode, an error message might appear when the print job is complete. In this case, check if the document was printed.

1After creating a document, open the [Printing Preferences] dialog box in the document's native application.

For details about displaying the [Printing Preferences] dialog box, see Displaying the Printing Preferences dialog box in an application.

2Make sure the [Setup] tab is selected.

3Configure the following settings:

  • Job Type:

    Select [Normal Print].

  • Copies:

    Specify the number of copies.

  • Orientation:

    Select the orientation of the document.

  • Color/ Black and White:

    Select [Color] for color printing, or [Black and White] for black-and-white printing.

4Click the [Paper] tab.

5Configure the following settings:

  • Document Size:

    Select the size of the document.

  • Input Tray:

    Select the paper tray that contains the paper you want to use for printing.

    If you select [Auto Tray Select], the paper tray is automatically selected according to the paper size and type specified.

  • Type:

    Select the type of paper that is loaded in the paper tray.

Change any other print settings as necessary. For details, see the printer driver Help.

You can set convenient print functions on the tabs of the printer driver. For details, see Convenient Print Functions.

6Click [OK].

7Start printing from the application's [Print] dialog box.

PreviousNext