Skip header
 

Connecting to the IEEE 1284 Interface

This section explains how to connect an IEEE 1284 interface cable to the IEEE 1284 interface board.

Important

  • If the main power switch is on, turn it off.

  • For connection to the IEEE 1284 interface board, use a half pitch 36-pin interface cable.

CAUTION

  • For users outside of North America: Properly shielded and grounded cables and connectors must be used for connections to a host computer (and/or peripheral) in order to meet emission limits.

  • For users in North America: Properly shielded and grounded cables and connectors must be used for connections to a host computer (and/or peripheral) in order to meet FCC emission limits.

1Make sure the main power switch on the printer is off.

2Turn off the main power switch of the host computer.

3Remove the cable cover.

Rear side of the printer illustration

4Connect an IEEE 1284 interface cable to the IEEE 1284 port.

Illustration of connecting the IEEE 1284 interface cable

You might have to use a conversion adapter to connect the cable to the interface. For details about acquiring a conversion adapter, contact your sales or service representative.

5Connect the other end of the cable into the interface connector on the host computer.

Before connecting the cable to the computer, check the shape of the connector. Connect the cable firmly.

6Attach the cable cover.

Rear side of the printer illustration

7Turn on the main power switch of the printer.

8Turn on the host computer.

When using Windows operating system, a printer driver installation screen might appear when the computer is turned on. If this happens, click [Cancel] on the screen.

Note

  • This printer does not come with an IEEE 1284 interface cable. Make sure you purchase the appropriate cable for the printer (connector shape) and your computer.

  • Use a five meter (16.4 foot) or shorter IEEE 1284 compatible cable that is compatible with the host computer.

PreviousNext