Previous
Specify dimensions for custom sizes.
Format
freesize=widthxheight
freesize=widthxheight/tr
freesize=widthxheight/tt
Value and behavior
Value |
Behavior |
|---|---|
width |
Specifies the width (length in the horizontal direction) of the paper in "mm". |
height |
Specifies the height (length in the vertical direction) of the paper in "mm". |
/tr |
Specifies a Paper Roll custom size. |
/tt |
Specifies a Paper Bypass custom size. |
Explanation
The dimensions may also be specified in mm, cm, inch (about 25.4 mm), pt (point) or dot units. In order to specify a size of 210 mm (width) and 510 mm (length), for instance, enter this printing option as follows:
freesize=210x520mm
If no unit is appended to the end of the value, the machine identifies the size assuming the value is specified in "mm".
The values specified for a custom size are not checked as to whether they are within the valid range.
If a value outside the specifiable range is specified, the paper of the size closest to the size that can be printed on is used.
If a Paper Bypass custom size is specified, change the Paper Bypass paper size to a custom size.
If the specified value exceeds the maximum specifiable value, printing is performed within the maximum specifiable range.
If the currently specified paper input location is not configured for a custom size paper, specify another paper input location that is configured for a custom size.
If "On" is specified for "U. Auto Paper Select" on the RTIFF Menu, this printing option may not be applied.
If "On" is specified for "X. Synchro Cut" on the RTIFF Menu or the "autopaper" printing option is specified with "freecut", priority can be given to custom size paper input locations.
