Previous
This section explains how to configure the WINS server.
The printer can be configured to register its NetBIOS name with a WINS server when the power is turned on. This enables the NetBIOS name of the printer to be specified from DeviceManager NX even in a DHCP environment.
The WINS server is supported by Windows Server 2003 or later.
For details about the WINS server settings, see Windows Help.
If there is no reply from the WINS server, the NetBIOS name is registered by broadcast.
The NetBIOS name can be entered using up to 15 alphanumeric characters.
Using Web Image Monitor
Start your Web browser.
Enter "http://(machine's IP address or host name) /" in the address bar to access the printer whose settings you want to change.
Click [Login].
The dialog box for entering the user name and password appears.
Enter the user name and password, and then click [Login].
Contact your administrator for information about the settings.
Depending on the configuration of your Web browser, the login user name and password might be saved. If you do not want to save them, configure your Web browser's settings so that this information is not saved.
In the menu area, click. Click [Configuration] on the [Device Management] menu.
Under “Network”, click [IPv4].
Check that [Active] is selected for [WINS] in the [Ethernet] column, and then enter the WINS server IPv4 address in [Primary WINS Server] and [Secondary WINS Server].
Click [OK].
“Updating...” appears. Wait for about one or two minutes, and then click [OK].
Quit Web Image Monitor.
For details about Web Image Monitor, see Using Web Image Monitor
.
