Previous
If the punch receptacle is full, remove punch waste by following the procedures stated in the animation that appears on the screen.
While “
Hole Punch Receptacle is full.” is displayed, you cannot use the Punch function.“
Hole Punch Receptacle is full.” is displayed until the punch waste box is reinstalled.If the message is still displayed, reinstall the punch waste box.
The message “
Hole Punch Receptacle is full.” may appear even when the punch waste box is not yet full. If this happens, the position of the punch waste box (indicated by the arrow as shown) may be blocked by punch waste. Remove the punch waste.3000-sheet finisher:
2000-sheet booklet finisher:
