Skip header
 

Top Page > Operating Instructions > Setting Up the Printer > Using a Print Server > Using NetWare > Setting up as a print server

Setting up as a print server

This section describes the setting procedure for network printers in the NetWare environment. In the NetWare environment, you can connect the printer as a "print server" or "remote printer".

Important

  • NetWare is disabled by default. Enable NetWare in "Interface Settings" under "System Settings" on the control panel. For details on how to enable NetWare using the control panel, see Interface Settings. You can also enable NetWare using Web Image Monitor. For details, see Web Image Monitor Help.

  • IPv6 cannot be used on this function.

  • To use this function, an optional NetWare unit is required.

Note

  • This function supports NetWare 6.5.

  • This procedure assumes an environment is already prepared for normal NetWare running the printing service setting.

  • The procedure is explained with the following example settings:

    • File server's name ...CAREE

    • Print server's name ...PSERV

    • Printer's name ...R-PRN

  • Queue name ...R-QUEUE

PreviousNext