Skip header
 

Tray Paper Settings

Important

  • If the specified paper size differs from the actual size of the paper loaded in the paper tray, a misfeed might occur because the correct paper size was not detected.

Paper Tray Priority: Printer

Specify the tray to supply paper for output.

Default: [Tray 1]

Tray Paper Size: Tray 1–4

Select the size of the paper loaded in the paper Tray 1–4. For details about available paper sizes, see Supported Paper for Each Input Tray.

[Tray Paper Size: Tray 3] can be selected only when the 1000-sheet paper feed unit or 2000-sheet paper feed unit is installed.

[Tray Paper Size: Tray 4] can be selected only when the 1000-sheet paper feed unit is installed.

Default: [Auto Detect]

Printer Bypass Paper Size

Select the size of the paper loaded in the bypass tray. For details about available paper sizes, see Supported Paper for Each Input Tray.

Default: [Auto Detect]

Paper Type: Bypass Tray

Select the type of the paper loaded in the bypass tray. For details about available paper types, see Supported Paper for Each Input Tray. For details about available paper thickness, see Notes about Paper Thickness.

  • Paper Type

    Default: [Plain Paper]

  • Paper Thickness

    Default: [Plain Paper]

  • Apply 2 sided

    Default: [Yes]

  • Apply Auto Paper Select

    Default: [No]

Paper Type: Tray 1–4

Select the type of the paper loaded in the Tray 1–4. For details about available paper types, see Supported Paper for Each Input Tray. For details about available paper thickness, see Notes about Paper Thickness.

[Paper Type: Tray 3] can be selected only when the 1000-sheet paper feed unit or 2000-sheet paper feed unit is installed.

[Paper Type: Tray 4] can be selected only when the 1000-sheet paper feed unit is installed.

You cannot set "Apply Auto Paper Select" when "Apply 2 sided" is set to [No] or the paper size is set to [Custom Size].

  • Paper Type

    Default: [Plain Paper]

  • Paper Thickness

    Default: [Plain Paper]

  • Apply 2 sided

    Default: [Yes]

  • Apply Auto Paper Select

    Default: [Yes]

Paper Type: LCT

Select the type of the paper loaded in the LCT (1200-sheet paper feed unit). For details about available paper types, see Supported Paper for Each Input Tray.

This item can be selected only when the LCT (1200-sheet paper feed unit) is installed.

You cannot set "Apply Auto Paper Select" when "Apply 2 sided" is set to [No] or the paper size is set to [Custom Size].

  • Paper Type

    Default: [Plain Paper]

  • Paper Thickness

    Default: [Plain Paper]

  • Apply 2 sided

    Default: [Yes]

  • Apply Auto Paper Select

    Default: [Yes]

Note