Skip header
 

Installing the Wireless LAN interface board

1Check the contents of the package.

2Turn the printer off and unplug the power cord.

3Loosen the two screws and remove the slot cover.

Controller board illustration

The removed cover will not be reused.

4Fully insert the interface board.

Interface unit illustration

Confirm that the interface board is firmly connected to the controller board.

5Tighten the two screws to secure the interface board.

Interface unit illustration

Note

  • Confirm that the board was correctly installed by printing the configuration page. If it is correctly installed, "Wireless LAN" will appear for "Device Connection" on the configuration page. For information about printing the configuration page, see Test Printing.

  • If the board was not installed properly, repeat the procedure from the beginning. If it cannot be installed correctly even after reattempting installation, contact your sales or service representative.

  • Before using the board, you must configure settings from the printer control panel. For details, see Wireless LAN Configuration.