Previous
When installing multiple options, the following order is recommended:
Attach the 1000-sheet paper feed unit or 2000-sheet paper feed unit
Either the 1000-sheet paper feed unit or 2000-sheet paper feed unit can be attached, but not both.
Attach the 1200-sheet paper feed unit
The 1000-sheet paper feed unit or 2000-sheet paper feed unit must have been attached.
To attach this option, contact your sales or service representative.
Install the SDRAM module
Install in the slot inside the controller board.
Install the hard disk
Install on the controller board.
Install the interface board
Install in the slot of the controller board.
Only one interface board can be installed.
Insert SD card options
Insert in the SD card slot of the controller board.
There are two slots for SD cards.
Each slot supports different types of SD cards.
If you want to use two or more SD cards that can be inserted in the same slot, contact your sales or service representative.
Attach the bridge unit
To attach this option, contact your sales or service representative.
Attach the 1000-sheet finisher or 3000-sheet finisher
Either the 1000-sheet finisher or 3000-sheet finisher can be attached, but not both.
The bridge unit and the 1000-sheet paper feed unit or 2000-sheet paper feed unit must have been attached.
To attach this option, contact your sales or service representative.
Attach the punch unit to the finisher
To attach this option, contact your sales or service representative.
Attach the output jogger unit to the 3000-sheet finisher
To attach this option, contact your sales or service representative.
