Loading Paper into Tray 1-3

Hold the tray grip, pull the tray halfway out, lift it slightly (), and then pull it out further ().

Pull the tray completely out. Take care not to drop it.

After pulling out the tray, check that no paper remains in the machine. If there are any remaining paper sheets, remove them.

Pinch the catch of the paper guide on the right side, slide the paper guides to match the size of paper you want to load, and then push the end paper guide out until there is space between them.

Load paper with the print side face down but not over the limit mark.

Squeeze the front end paper guide, and then slide it to meet the edge of the paper.

Push the tray gently in until it stops.

Before you push tray 1 in, make sure the output ramp is closed.

Pull out the output ramp extension.