Skip header
 

Removing Jammed Staples

If a staple jam occurs, remove the jammed staple by following the procedures stated in the animation that appears on the screen. This section describes how to remove jammed staples when the procedure is not displayed on the screen.

CAUTION

  • Keep your hands clear of the booklet finisher tray when removing misfed paper, pulling out or pushing in the finisher's staple unit. You can trap and injure your fingers if you do not.

Important

  • Curled paper may cause staples to jam. To avoid this, turn paper over in the tray.

  • When using the Finisher SR4060 or Booklet Finisher SR4070, after removing jammed staples, the stapler will automatically staple up to 10 times without stapling paper. When the Finisher SR4080 is installed, after removing jammed staples, the stapler will automatically staple up to 30 times without stapling paper.

Note

  • Remove the jammed staples according to the finisher type. Check the type if you are unsure. For details about type of finisher, see "Guide to Functions of the Machine's Options", Getting Started.

Related topics

Finisher SR4060
Booklet Finisher SR4070
Booklet Finisher SR4070 (Saddle Stitch)
Finisher SR4080
PreviousNext