Skip header
 

Connecting to the Ethernet Interface

This section describes how to connect an Ethernet cable to the Ethernet interface.

CAUTION


  • Properly shielded and grounded cables and connectors must be used for connections to a host computer (and/or peripheral) in order to meet emission limits.

Important

  • If the main power switch is on, turn it off.

  • Use the following Ethernet cables.

    • Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5 or more

1Make a loop 3 cm (1.2 inches) (1) from the end of the Ethernet cable and attach the included ferrite core to the loop as shown.

illustration of Ethernet cable with ferrite core

2Make sure the main power is switched off.

3Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.

illustration of connecting the Ethernet interface cable

4Connect the other end of the Ethernet interface cable to a network connection device such as a hub.

5Turn on the main power switch of the machine.

10BASE-T/100BASE-TX port illustration (numbered callout illustration)

  1. Indicator (orange)

    When 100BASE-TX is operating, the LED is lit orange. When 10BASE-T is operating, it is turned off.

  2. Indicator (green)

    When 10BASE-T is operating, the LED is lit green. When 100BASE-TX is operating, it is turned off.

Note

  • If the machine enters the Energy Saver mode, both LEDs may go off.

  • Use an Ethernet interface cable that supports "Ethernet Speed". If you select [Auto Select] for "Ethernet Speed", use an Ethernet interface cable that supports 100BASE-TX.

  • For details about how to turn on the main power switch, see "Turning On the Main Power", Getting Started.

  • For details about installing the printer driver, see "Installing the Printer Driver", Driver Installation Guide.