Skip header
 

Top Page > Network Guide > Appendix > Remote Maintenance by telnet > Commands List > SLP

SLP

Use the “slp” command to configure SLP settings.

Use the “slp” command to configure the value of TTL used by the SLP multi-cast-packet.

Note

  • The default value of TTL is “1”. A search is executed only within a local segment. If the router does not support multi-cast, the settings are not available even if the TTL value is increased.

  • The acceptable TTL value is 1 - 255.

    msh> slp ttl {1 - 255}